论文部分内容阅读
1.上车前,应先环视农用车周围情况,并查看前轮的转向位置。 2.启动发动机后,应先检查仪表盘,看各表工作是否正常。若车辆负荷较大,应在起步前,先给发动机加温,水温达到50℃以上,方能起步。 3.彻底踏下离合器踏板,根据路面情况和车辆的负载状况,选用一挡或二挡起步。 4.鸣喇叭,同时观察前方、左右、上方及后视镜,察看有无妨碍起步的因素或情况。 5.左手握稳方向盘,右手握住手制动杆并用拇指按下杆端按钮。 6.起步时,先稍快抬起离合器踏板,当听到发动机声音略有变化(声音减弱),车身稍有抖动时,稍停一下离合器踏板,同时徐徐踏加速踏板,并缓慢松抬离合器踏板,放松手制动杆,使农用车平稳起步。若车辆载重较大或道路较差,离合器踏板后半行程
1. Before getting on the bus, you should look around the agricultural vehicles and check the steering position of the front wheels. 2. Start the engine, you should first check the dashboard to see if the work of the table is normal. If the vehicle load is larger, it should be before starting, to the engine to warm, water temperature reached above 50 ℃, before starting. 3. Completely depress the clutch pedal, according to the road conditions and the load status of the vehicle, choose a gear or two gear to start. 4. Honk, while watching the front, left and right, above and rear-view mirror to see if there are any factors that prevent the start or situation. 5. Hold the steering wheel with your left hand, hold the hand brake lever with your right hand and press the lever end button with your thumb. 6. When starting, raise the clutch pedal a little earlier. When you hear a slight change in engine sound (sound weaker) and the body slightly jerky, briefly stop the clutch pedal while slowly depressing the accelerator pedal and slowly releasing the clutch pedal , Relax the hand brake lever, make the farm car steady start. If the vehicle is heavy or the road is poor, the second half of the clutch pedal travel