论文部分内容阅读
The strength of cement substituted mortar decreases with the increase in fly ash amount,whereas the strength increases when the fly ash is blended as sand substitute.A mortar with highest strength (compressive strength=30.2 Mpa;flexural strength=7.0 Mpa) was obtained when the sand replacement ratio was 0.75％.The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5％ and 25％.The k values of fly ash used for sand replacement were all significantly above that used for cement substitution.The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement,providing an explanation for the strength enhancement.The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching,indicating the reuse possibility of fly ash blended mortar.For the mortar with the mass ratio of fly ash to binder of 0.5％,the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 107 and 0.06,respectively;these results were both lower than the threshold values,showing an acceptable health risk.The CR (9.89 × 10-5) and HQ (3.89) of the nonsensitive scenario for fly ash treatment exceeded the acceptable threshold values,indicating health risks to onsite workers.The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd,respectively.The CR and HQ from inhalation was the main route of heavy metal exposure.