A mechanistic model of heat transfer for gas-liquid flow in vertical wellbore annuli

来源 :石油科学(英文版) | 被引量 : 0次 | 上传用户:blanknan
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The most prominent aspect of multiphase flow is the variation in the physical distribution of the phases in the flow conduit known as the flow pattern.Several different flow pattems can exist under different flow conditions which have significant effects on liquid holdup,pressure gradient and heat transfer.Gas-liquid two-phase flow in an annulus can be found in a variety of practical situations.In high rate oil and gas production,it may be beneficial to flow fluids vertically through the annulus configuration between well tubing and casing.The flow patterns in annuli are different from pipe flow.There are both casing and tubing liquid films in slug flow and annular flow in the annulus.Multiphase heat transfer depends on the hydrodynamic behavior of the flow.There are very limited research results that can be found in the open literature for multiphase heat transfer in wellbore annuli.A mechanistic model of multiphase heat transfer is developed for different flow patterns of upward gas-liquid flow in vertical annuli.The required local flow parameters are predicted by use of the hydraulic model of steady-state multiphase flow in wellbore annuli recently developed by Yin et al.The modified heat-transfer model for single gas or liquid flow is verified by comparison with Manabe\'s experimental results.For different flow patterns,it is compared with modified unified Zhang et al.model based on representative diameters.
其他文献
Supported ionic liquid (IL) catalysts [Cnmim]3PMo12O40/Am TiO2 (amorphous TiO2) were synthesized through a one-step method for extraction coupled catalytic oxidative desulfurization (ECODS) system.Characterizations such as FTIR,DRS,wide-angle XRD,N2 adsor
Owing to the increasingly serious environmental issues caused by the sulfur burnt in fuel,desulfurization has become an important topic.In this work,an amphiphilic oxygen-defective tungsten oxide was synthesized by a colloidal chemistry method.The amphiph
Deep eutectic solvents (DESs) are a new class of green solvents analogous to ionic liquids due to their biodegradable capacity and low cost.However,the direct extractive desulfurization of diesel oil by DESs cannot meet the government\'s standard.In thi
With the aim of deep desulfurization,silica-supported polyoxometalate-based ionic liquids were successfully prepared by a one-pot hydrothermal process and employed in heterogeneous oxidative desulfurization of various sulfur compounds.The compositions and
Adsorbent regeneration is critical for a continuous adsorption-regeneration process and often underestimated.In this work,the regeneration of bifunctional AgxO@SBA-15 for [O]-induced reactive adsorptive desulfurization of liquid fuel is reported and furth
Hydraulic fracturing technology can significantly increase oil production from tight oil formations,but performance data show that production declines rapidly.In the long term,it is necessary to increase the development efficiency of block matrix,surfacta
To improve the rate of penetration (ROP) in drilling deep and hard formations,this paper proposes a new drilling method called coiled tubing partial underbalanced drilling (CT-PUBD).As a preliminary investigation into the new drilling method,this paper pr
To investigate the efficiency and stability of Venezuela\'s oil-oriented economy,this paper applied entropy to the analysis.Based on this method,Venezuela\'s oil-centered industry,inefficient regulatory system,and insensitive response to external chan
Wellbore failure can occur at different stages of operations.For example,wellbore collapse might happen during drilling and/or during production.The drilling process results in the removal of an already stressed rock material.If the induced stresses near
Less than 10% of oil is usually recovered from liquid-rich shales and this leaves much room for improvement,while water injection into shale formation is virtually impossible because of the extremely low permeability of the formation matrix.Injecting carb