Threshold level and gain of forward stimulated Brillouin scattering in a forward pumped s-band discr

来源 :Optoelectronics Letters | 被引量 : 0次 | 上传用户:michael_lv
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Amplification effect of forward stimulated Brillouin scattering (SBS) lines on the forward pumped s-band discrete DCF fiber Raman amplifier (FRA) has been studied.Pump threshold power of the forward first order Stokes SBS (FSB1- ),second order Stokes SBS (FSB2-) and third order SBS (FSB3-) in the forward pumped FRA are 1.5 mW,1.4 mW and 1.7 mW,respectively.The Stokes SBS lines are amplified by FRA and fiber Brillouin amplifier (FBA) at the same time.Gain of amplification is given as G_A=G_R·G_B,where G_R is Raman gain and G_B is Brillouin gain.Saturation gain of FSB1-,FSB2- and FSB3- are about 52 dB,65 dB and 65 dB,respectively.The saturation Raman gain of 10 km DCF forward FRA is about 14 dB,so Brillouin gain of FSB1-,FSB2- and FSB3- are about 38 dB,51 dB and 51 dB,respectively.The forward cascaded SBS lines have been observed. Amplification effect of forward stimulated Brillouin scattering (SBS) lines on the forward pumped s-band discrete DCF fiber Raman amplifier (FRA) has been studied. Pump threshold power of the forward first order Stokes SBS (FSB1-), second order Stokes SBS ( FSB2-) and third order SBS (FSB3-) in the forward pumped FRA are 1.5 mW, 1.4 mW and 1.7 mW, respectively. The Stokes SBS lines are amplified by FRA and fiber Brillouin amplifier (FBA) at the same time. Gain of amplification is given as G_A = G_R.G_B, where G_R is Raman gain and G_B is Brillouin gain. Attenuation gain of FSB1-, FSB2- and FSB3- are about 52 dB, 65 dB and 65 dB, respectively. The saturation Raman gain of 10 km DCF forward FRA is about 14 dB, so Brillouin gain of FSB1-, FSB2- and FSB3- are about 38 dB, 51 dB and 51 dB, respectively. The forward cascaded SBS lines have been observed.
其他文献
新疆柯坪一带的晚石炭世一早二叠世的地层发育广泛,化石丰富。从十九世纪末叶始,断续有中外研究者进行地质调查,解放以后开展了二十万分之一的区调及各项专题研究,其中1928
SENTIR和SESENTIR□苏州大学庄乐群sentir和sesentir在词义及用法上看似十分相近,其实存在着不小的区别。初学者常因不辨其中的差异,将两者混为一谈,造成了许多错误。现在就让我们对它们的用法作一简单的分析
我厂为自贡市大安盐厂试制了两台 F=500M~2,花板是 TA_2—A_3钛钢复合板的列管式加热器。由于钛材与钢材的性能不同,所以钛钢复合板的机械加工具有以下三个特点:一、钛材 I
0600238 光刻胶线边沿粗糙度量化Ⅰ上下扫描电子显微图象的离线与在线分析=Quantification of line-edge roughness of photorsists.I.A comparison between off-line and onli
本文通过大量的工艺性试验及装机使用验证,“高速锤挤压形变热处理制取半精锻毛坯无余量冷精轧叶身型面稳定回火”的压气机叶片生产新工艺是可行的,从而为叶片生产开避了新的
随着人口的增长和经济的发展,技术手段的增强,加上种种社会活动频繁,人类施加于森林的压力越来越大,人类既可以改变或破坏森林生态系统,也可以调节森林生态系统使之受到保护,
在北京这块古老的土地上,历代劳动人民以深邃的聪明才智和卓越的创造精神,建造了无数的旷世之作,为后人留下了沉积厚重的历史文化遗产。京城中轴线,向世人展示着中华民族建筑
我厂产品中有几种如图1所示的零件。这类零件的共同特点是:内部都有一个很深的锥孔。由于没有专用设备,又无经验,用普通方法无法加工.过去有一段时期成为难题。后来经过努力
Monodispersed silica microspheres with diameter of 353nm were assembled into photonic crystal in ethanol colloidal suspensions of varied silica volume fractio
一.前言铸造工厂散发出来的大量粉尘,严重污染着周围环境,必须尽快解决,刻不容缓。冲天炉炉气净化是其中的一个重要方面。一九七八年根据上级下达的任务,我们两单位合作完成