• 不 限
  • 期刊论文
  • 硕博论文
  • 会议论文
  • 报 纸
  • 英文论文
  2. 您的位置
  3. 首页
  4. 期刊论文
  5. Thermo-Calc calculations and studies of the heating process of Fe83Si4B13 alloy

Thermo-Calc calculations and studies of the heating process of Fe83Si4B13 alloy

来源 :宝钢技术研究：英文版 | 被引量 : 0次 | 上传用户：taishao
【摘 要】
：
The microstructural changes of Fe83Si4B13 amorphous mother alloy during the heating process were investigated by Laser Scanning Confocal Microscopy（ LSCM）,and the
【作 者】
：
MA Changsong WANG Chengquan SU 
【机 构】
：
ResearchInstitute
【出 处】
：
宝钢技术研究：英文版
【发表日期】
：
2015年1期
【关键词】
：
加热过程 计算值 母合金 激光扫描共聚焦显微镜 差示扫描量热法 LSCM DSC 微观结构 Fe-Si-B ternary alloy  heating pro 
【基金项目】
：
Special thanks are due to engineer MIXiaochuang and ZHU Lulin for experimental help.
下载到本地 , 更方便阅读
下载此文 赞助VIP
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The microstructural changes of Fe83Si4B13 amorphous mother alloy during the heating process were investigated by Laser Scanning Confocal Microscopy（ LSCM）,and the phase transformation was determined by the Thermo-Calc calculations. The differences in the
其他文献
Field girth weldability evaluation of X70 UOE pipeline
Based on API STD 1104-2005 and CSA Z662-2007,field girth welding tests and girth weldability evaluations were executed for three types of wall thickness X70 UOE
期刊
X70焊接性UOE评价环缝管线熔化极气体保护焊裂纹尖端张开位移X70 UOE pipeline girth weldability au
Effect of substrate grain size on GA streaky marks of IF steel
The micro-characteristics of the streaky marks and the corresponding substrate surface of galvannealed(GA)steel sheets have been investigated using SEM and FIB.
期刊
晶粒尺寸效应遗传标记IF钢基板合金化热镀锌表面质量晶粒边界颗粒大小IF steel galvannealed steel streaky m
Research and development of blasting abrasive made of steelmaking slag
This study focuses on the development of a newtype of nonmetallic steelmaking slag abrasive. The performance,processing,and application of steelmaking slag as a
期刊
研究与开发磨料炼钢废渣爆破船舶甲板加工方法炼钢渣化学成分steelmaking slag derusting abrasive recycl
Process for improving the ladle free-opening rate for high aluminum steel in continuous casting
Steel 20Mn23AlV is a type of high aluminum steel with a very low ladle free-opening rate. The aluminum composition of 20Mn23AlV ranges from 1. 6% to 2. 45%,whic
期刊
钢水包开放率铝钢免费连铸精炼过程开口率钢包continuous casting high aluminum steel ladle
High-temperature oxidation behavior of heat resistant stainless steel 1.4828
The kinetic curves of the high-temperature oxidation of austenitic heat resistant stainless steel 1.4828 at1050℃ were measured using a weighing method.It is sh
期刊
高温氧化行为耐热不锈钢X射线衍射分析扫描电子显微镜动力学曲线不锈钢管表面形态氧化物1. 4828 heat resistant stainl
The effect of different cooling and tempering conditions on the strength and toughness of SA533B ste
The microstructure and mechanical properties of SA533B low-alloy steel were investigated under different cooling and tempering conditions. Steel plates cooled a
期刊
回火马氏体冷却速度低合金钢韧性强度脆性转变温度显微组织贝氏体钢SA533B steel cooling rate tempering st
一种应用于DC-DC的新型基准源电路设计
主要介绍了一种新型CMOS基准源电路的设计方法,由NMOS管阈值电压的温度系数及NMOS管迁移率温度指数形成温度补偿,同时产生低温度系数的基准电压和基准电流.此基准源电路已经
期刊
DC-DC转换器基准电压基准电流阈值电压迁移率DC-DC converters voltage reference current referen
Investigation of a novel spot defect on a hot dip galvanized high-silicon AHSS sheet
Improving the galvanizability of high silicon advanced high strength steels(AHSS) is a practical technical challenge. In this study,spot defects on an industria
期刊
热镀锌钢板缺陷调查高硅金属间化合物扫描电子显微镜氧化硅薄膜能量色散谱仪光学显微镜high Si containing AHSS galvan
Experimental study on the causes of cracking of high-strength steel during bending
This paper studies the chemical composition,tensile properties,inclusions,metallogrophic structure,and other such parameters to identify the causes of cracking
期刊
高强度钢板弯曲过程原因实验开裂横向裂缝表面裂缝化学成分bending cracking high-strength steel incl
一维有限孔径时谐辐射的一种解析分析
给出了计算一维有限孔径时谐辐射的一种简单的解析描述。根据线源叠加理论，在Fresnel近似条件下推得一计算辐射场的积分公式。通过用矩形函数对孔径上场分布函数的加权，并利用
期刊
孔径辐射高斯展开Kirchhoff积分aperture radiation gaussian expansion kirchhoff integrat