论文部分内容阅读
Q2014B型喷刃器(图1)是青岛铸造机械厂1966年1月份试制成功的新产品。该机用喷射的铁丸来清理落砂后的铸件、雄件或经过热处理后零件表而的殘余型砂、氧化皮或浮锈。该机由上室、下室、浪合室、锥形阀、上罩、检查窗、管道系统、喷头等部件所组成。上罩与上室及上室与下室之间各有一雄形阴。操纵侧换开关,控制气流,即可使上、下锥形阀一起一落,而使上罩的铁丸通过上室进八下室,保持连续喷射。铁丸由上室樱底座流八混合室内。物动转轴,即可控制喷丸量的大小。当铁丸靠自重落入混合室的套筒处时,即被管道系统吹来的压缩空气推动,从而使铁丸通过喷砂耐压胶管及喷咀喷出。
Q2014B-type jet-edge device (Figure 1) is Qingdao Foundry Machinery Factory in January 1966 trial success of new products. This machine uses the shot iron pellet to clean the sand casting, the male or the heat-treated parts after the surface of the residual sand, scale or rust. The aircraft from the upper chamber, lower chamber, Langhe room, conical valve, the hood, inspection windows, piping systems, nozzles and other components. On the hood and the upper chamber and the upper chamber and the lower chamber have a male shade. Control side of the switch, control air flow, you can make the upper and lower cone valve down together, leaving the upper iron pill through the upper chamber into the eight room, to maintain continuous injection. Iron pills from the Sakura base on the flow eight mixing room. Material moving shaft, you can control the amount of shot peening. When the iron ball falls into the sleeve of the mixing chamber by its own weight, it is pushed by the compressed air blown by the pipe system, so that the iron ball is ejected through the sandblasting pressure-resistant hose and the nozzle.