【摘 要】
：
In this article,the thermal-hydraulic efficacy of a boehmite nanofluid with various particle shapes is eval-uated inside a microchannel heat sink.The study is done for particle shapes of platelet,cylinder,blade,brick,and oblate spheroid at Reynolds number
【机 构】
：
Institute of Research and Development,Duy Tan University,Da Nang 550000,Vietnam;Department of Mechan
论文部分内容阅读
In this article,the thermal-hydraulic efficacy of a boehmite nanofluid with various particle shapes is eval-uated inside a microchannel heat sink.The study is done for particle shapes of platelet,cylinder,blade,brick,and oblate spheroid at Reynolds numbers (Re) of 300,800,1300,and 1800.The particle volume fraction is assumed invariant for all of the nanoparticle shapes.The heat transfer coefficient (h),flow irregularities,pressure loss,and pumping power heighten by the elevation of the Re for all of the nanoparticle shapes.Also,the nanofluid having the platelet-shaped nanoparticles leads to the greatest h,and the nanofluid having the oblate spheroid particles has the lowest h and smallest pressure loss.In contrast,the nanofluid having the platelet-shaped nanoparticles leads to the highest pressure loss.The mean temperature of the bottom surface,thermal resistance,and temperature distribution unifor-mity decrease by the rise in the Reynolds number for all of the particle shapes.Also,the best distribution of the temperature and the lowest thermal resistance are observed for the suspension containing the pla-telet particles.Thereby,the thermal resistance of the nanofluid with the platelet particles shows a 9.5％decrement compared to that with the oblate spheroid particles at Re =300.For all the nanoparticle shapes,the figure of merit (FoM) uplifts by elevating the Re,while the nanofluids containing the brick-and oblate spheroid-shaped nanoparticles demonstrate the highest FoM values.
其他文献
采用热法制氯化铵工艺处理部分过滤母液,工艺过程为纳滤、MVR蒸发、真空结晶,可制备纯度较好的氯化铵,并使热法工艺与冷法互补,达到控制母液膨胀,减小循环量的目的.
An analysis approach considering gas-solids hydrodynamics,reaction kinetics and reacting species non-uniformity together in a dual-reactor system is presented for better understanding its mass and energy balance.It was achieved by a 3-dimensional comprehe
主要介绍了重灰自身返碱煅烧炉炉头预混段结构及相关组件的作用,同时针对炉头预混段内抄板频繁脱落的问题分析原因并给出加固改进方法,以供同行参考.
2 ?014 年,青龙寺煤矿在工作面回风巷用两架一组 形式的超前液压支架代替单体支护,解决了单体支护推进速度慢、支护强度低、支护面积小、支设和回撤劳动强度大、安全系数低、维修成本高等问题.但是工作面运输巷由于巷道高度低、转载机短、配套设备体积大等因素,无法布置两架一组形式的超前液压支架,仍然采用单体支护.2021 年青龙寺煤矿与郑煤机集团合作研制了单列超前支架,解决了工作面运输巷的支护问题[1-4].
In this research gasoil desalting was investigated from mass transfer point of view in an eductor liquid-liquid extraction column (eductor-LLE device).Mass transfer characteristics of the eductor-LLE device were evaluated and an empirical correlation was
介绍了氯化铵的回转干燥工艺.从工艺、能耗、环保、非满负荷工况等方面对内加热流化床工艺和回转干燥工艺进行了对比分析.研究证明,回转干燥工艺的汽耗、电耗、尾气排放量均大幅度低于内加热流化床工艺.在非满负荷工况时,效果更加显著.
采用系统循环母液保温转化-冷结晶纯化工艺对国外某含氟天然碱进行除氟工艺技术研究,除氟率达到83.42％.经除氟后的转化母液冷却结晶得到十水碱,再通过热溶精制、蒸发结晶和煅烧分解得到高品质重质纯碱,纯度高达99.5％以上,解决了含氟天然碱精制提纯重质纯碱的关键技术难题.本技术成功回收了系统母液,提高了资源利用效率,同时副产的含氟渣通过精制也可制成NaF用于涂装工业等领域,为含氟天然碱的绿色开发奠定了理论基础.
In the present study,the effects of relative humidity on filtrating coal-fired fly ash with hydrophobic poly tetra fluoroethylene (PTFE) membranes were investigated.The intergranular force of particulate matter at different RH conditions was measured by a
Deterioration and loss of quality of vegetable oil is a big challenge in the food industry.This study inves-tigated the synthesis of nickel ferrite (NiFe2O4) via co-precipitation method and its use for the removal of free fatty acids (FFAs) in deteriorate
Increasing importance of heat transfer in chemical engineering science causes that investigation in the field of enhancement techniques is always one of the up-to-date topics for study.In the current compar-ative analysis,the thermal enhancement and frict