论文部分内容阅读
高医油漆喷枪喷嘴结构如图1所示,材料为硬质合金,喷嘴开口的大小和角度均有严格的要求。角度a的大小以及其与内球面相交的截面形状直接影响开口的宽度和长度。在力口工中是以A面作为定位基准,在数控线切割机床上切割喷嘴开口角度a。由于工件深邃H尺寸不一致,故需先测出H的实际尺寸,通过基准尺寸换算后,再进行切割加工,以保证喷嘴开口的宽度和长空。喷嘴微孔直径d的大小与油漆的种类和浓度等因素有关,一般孔径为φ0.15～φ0.4mm。这样小的孔径,用一般的量具是不易测量H值的。为此,
High-tech paint spray gun nozzle structure shown in Figure 1, the material is cemented carbide, nozzle opening size and angle have strict requirements. The size of angle a and its cross-sectional shape intersecting the inner sphere directly affect the width and length of the opening. In the mouth of labor is based on the A side as a benchmark in the NC cutting machine cutting nozzle opening angle a. As the depth of the workpiece H is inconsistent, so you need to measure the actual size of H, converted by the reference size, and then cut to ensure the nozzle opening width and the sky. The size of the nozzle pore diameter d and paint the type and concentration and other factors, the general aperture of φ0.15 ~ φ0.4mm. Such a small aperture, with the general gauge is not easy to measure the H value. to this end,