Radial Forces in a Centrifugal Compressor; Experimental Investigation by Using Magnetic Bearings and

• 作 者: Arttu REUNANEN Jaakko LARJOLA
• 机 构: Department of Energy and Environmental Technology Lappeenranta University of Technology,Lappeenranta
• 出 处: Journal of Thermal Science
• 发表日期: 2005年01期
• 关键词: bearings radial compressor centrifugal moderate outlet stall inlet removed sligh

The volute of a centrifugal compressor causes a non-uniform pressure distribution which leads to a radial force on the impeller. This force was measured using magnetic bearings. In addition, the radial force was estimated using the static pressure distribution measured at the impeller outlet. The impeller force was found to be the highest at choke, the lowest at the design flow and moderate at stall. The radial force determined from the pressure measurements was only slightly different from the force obtained from the bearing measurements. The rotational speed was seen to affect the force to some extent.

The volute of a centrifugal compressor causes a non-uniform pressure distribution which leads to a radial force on the impeller. This addition is the radial force was estimated using the static pressure distribution measured at the impeller outlet. The impeller force was found to be the highest at choke, the lowest at the design flow and moderate at stall. The radial force determined from the pressure was was slightly slightly from the force obtained from the bearing measurements. The rotational speed was seen to affect the force to some extent.