离心珩磨工具

• 机 构: 沈阳鼓风机厂,
• 出 处: 机械工人技术资料
• 发表日期: 1973年06期
• 关键词: 内孔加工 技术不熟练 下限 刮刀 孔径尺寸 青年工人 钻床 较好 往复移动 零件精度

各种盘、轮内孔加工时,由于季节温度的差别或一些青年工人技术不熟练,怕出废品,有的零件孔径尺寸往往走下限或小于下限,而后用刮刀手工修孔,既累又相当费工。针对这种情况,我厂在1970年初制成了离心珩磨工具,经两年多使用证明,效果较好,很受工人欢迎。

Various disc, wheel hole processing, due to differences in seasonal temperature or some young workers unskilled, afraid of the waste, and some parts of the aperture size often go below the limit or less than the lower limit, and then manually scoring with a knife, both tired and quite Fatigue. In response to this situation, I plant in early 1970 made centrifugal honing tools, after two years of use proved to be better, very welcomed by workers.