论文部分内容阅读
在机器制造厂里,车制各种不同半径的圆角,多是用移动大刀架和小刀架及样板,来完成其切削任务。但在大量生产中,用此法来制造,生产效率很低,质量也不合规定。这里介绍我厂车制圆角的方法,以供大家参考:——如[图一]所示:1车头,2工作物,3六角螺丝,4刀架,5车刀,6固定器,7螺帽,8手柄,9转动板,10固定轴,11螺丝,12弹子,13刀架座,14大刀架。它的构造和原理都很简单。图中除车头和工作物外,便是车制方法中的工具了。刀架座13,是把小刀架取去后,用螺钉11固定在大刀架上的周天磨盘上。在刀架座13上和
In the machine shop, the car made of a variety of different radius of the fillet, mostly with a large turret and a small knife holder and a model to complete its cutting tasks. However, in mass production, this method is used to manufacture, which has low production efficiency and poor quality. Here I introduce the factory car fillet method for your reference: - as shown in Figure 1: 1 front, 2 work, 3 hex screws, 4 turret, 5 lathe knife, 6 fixtures, 7 Nut, 8 handle, 9 rotating plate, 10 fixed shaft, 11 screws, 12 pin, 13 turret seat, 14 turret. Its structure and principle are very simple. In addition to the front and the work of the figure outside, is the vehicle system tools. Turret seat 13, is to take the knife holder, with a screw 11 is fixed on the turret on the Sunday grinding disc. On the holder 13 and