【摘 要】
：
Real-time video streaming using ultra-wideband (UWB) technology is experimentally demonstrated along long-reach passive optical networks (LR-PONs) with different wired and wireless reaches. Experimental tests using external and direct modulation with UWB
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
Real-time video streaming using ultra-wideband (UWB) technology is experimentally demonstrated along long-reach passive optical networks (LR-PONs) with different wired and wireless reaches. Experimental tests using external and direct modulation with UWB wireless radiation in the 10- and 60-GHz bands are performed. An ultra-bendable fiber is also considered for a last-mile distribution. The video quality at the output of the optical fiber infrastructure of the LR-PON is assessed using the error vector magnitude (EVM), and the link quality indicator (LQI) is used as a figure of merit after wireless radiation. An EVM below –17 dB is achieved for both externally and directly modulated LR-PONs comprising up to 125 km of optical fiber. EVM improvement is observed for longer LR-PONs when directly modulated lasers (DMLs) are used because of the amplitude gain provided by the combined effect of dispersion and DML's chirp. Compared with optical back-to-back operation, the LQI level degrades to the maximum around 20% for LR-PONs ranging between 75 and 125 km of fiber reach and with a wireless coverage of 2 m in the 10-GHz UWB band. The same level of LQI degradation is observed using the 60-GHz UWB band with a LR-PON integrating 101 km of access network, a last-mile distribution using ultra-bendable fiber, and a 5.2-m wireless link.
其他文献
以252Cf中子源驱动噪声分析测量法为依据，利用中子脉冲信号自相关函数与被测核材料(252U)质量的关系，设计了一种基于神经网络的核材料质量识别方法，探索借助时域特征进行质量识别的有效性。利用平稳小波变换抑制中子统计涨落对自相关函数带来的影响，利用分布式Elman神经网络对不同质量核材料的自相关函数样本进行训练和识别，并研究了有限样本前提下不同子网个数对最终识别结果所造成的影响。对4种核材料质量共计120组样本进行的实验，结果表明：在理想实验条件下，平稳小波变换抑制了统计涨落对信号自相关函数的影响；分布式
针对单晶硅柱面镜加工过程中面临的加工效率低、加工精度差以及表面质量难控等问题,提出采用离子束倾斜入射的方法来进行单晶硅柱面镜的加工工艺优化。通过建立离子束倾斜入射的去除函数理论模型,揭示去除效率同入射角度的关联规律;通过分析离子束倾斜入射的微观形貌作用机理,揭示表面质量同入射角度的关联规律;综合优化去除效率和表面质量,获得倾斜入射的最佳入射角度,并建立基于离子束倾斜入射的新工艺路线。在一块尺寸为100 mm×100 mm的单晶硅凸柱面镜上采用新工艺路线进行加工实验,结果表明:在保证加工精度和表面质量的情况
2015年12月份重污染频发的北京市先后启动两次大气重污染红色预警。本研究根据中科院大气物理研究所铁塔分部激光雷达的立体探测数据, 采用梯度法反演北京市区大气边界层高度, 并对中尺度数值模式WRF的模拟结果进行评估。结果表明, 虽然两种方法的结果具有较好的一致性, 但是极值并没有很好地吻合。激光雷达反演边界层高度日变化与WRF模拟结果的相关性达到0.76, 均方根误差为163 m, 平均偏差为-61 m。同时发现在清洁天气下, WRF模拟的准确性要高于污染天气下的模拟结果。此外地面观测的PM2.5质量浓度
A deep binary silicon grating as high-extinction-ratio reflective polarizing beam splitter (PBS) at the wavelength of 1550 nm is presented. The design is based on the phenomenon of total internal reflection (TIR) by using the rigorous coupled wave analysi
On the basis of optical property of cube corner retroreflector (CCR), a new perception and calculation approach for diffraction aperture of CCR in two different forms is presented. The relationship between diffraction apertures and incident light with six
There is a misprint in the text of Figs. 3 and 4. The text on the bottom part of Figs. 3 and 4 should be “100 fs pulse Photoexcitation” and “1 fs pulse Photoexcitation” respectively. This error does not affect any conclusions in this work, and it has been
任何想使光束或其他辐射精确聚焦的企图都将在较这个波长略大的区域内产生复杂的辐射图案。这种衍射图案由附加不同滞后量的不同强度的波产生。在聚焦激光效应的研究中，它是特别有趣的。
利用再发射技术能够有效测量早期辐射驱动对称性。2011年在神光Ⅱ激光装置上，采用Bi替代靶，通过改变靶丸的支撑方式和优化探测器配置，利用分幅相机获得较高信噪比的Bi球表面再发射图像。利用实验结果获得了入射流不对称性P2分量随时间的变化，对比两种腔长的黑腔，P2分量随时间的变化存在明显差别。两种腔P2分量随时间的变化趋势与采用视角因子模拟的结果基本一致。