论文部分内容阅读
看一下图4,我自己做的样机,注意缚在 ADXL150引脚上的线绕金属丝。我用双面面包板把′150放置在14针线绕插槽上,把金属丝的活动端缚在插槽的针上。把插槽插入样机电路板并焊接在适当位置后,我剪掉过长的插槽针因为它们是不需要的。注意到在样机中,我把金属丝焊接到′150上的每根针,不过这不是必需的。只需焊接7,8,9,10针,14针需要接到其他位置。(9针是自检功能,在这个项目中不使用)
Take a look at Figure 4, my own prototype, paying attention to the wire wound around the ADXL150 pin. I put the ’150’ on the 14-pin wire-wound socket with a double-sided breadboard and tied the wire’s activity to the socket pin. After inserting the slot into the prototype circuit board and soldering it in place, I cut off the long slot pins because they are not needed. Notice that in the prototype, I soldered the wire to each needle on the ’150 but this is not required. Just welding 7,8,9,10 needles, 14 need to receive other locations. (9-pin self-test function, not used in this project)