论文部分内容阅读
A typical electronic communication system, such as GPS receiver, unmanned aerial vehicle’s(UAV’s) data link, and radar, faces multi-dimensional and complicated electromagnetic interference in operating environment. To measure the antiinterference performance of the electronic communication system in the complicated electromagnetic interference environment, a method of multi-dimensional and complicated electromagnetic interference hardware-in-the-loop simulation in an anechoic room is proposed. It takes into account the characteristics of interference signals and the positional relationship among interference, the receiver and the transmitter of the electronic communication system.It uses the grey relational method and the angular domain mapping error correction method to control the relevant parameters,the microwave switch and so on, thus achieving the approximately actual mapping of the outdoor multi-dimensional and complicated electromagnetic interference in the anechoic room. To verify the effectiveness of this method, the multi-dimensional and complicated electromagnetic interference of the UAV’s data link is simulated as an example. The results show that the degree of correlation between the calculated signal to interference ratio of the data link receiver in the actual scene and the measured signal to interference ratio of the data link receiver simulated with this method in the anechoic room is 0.968 1, proving that the method is effective for simulating the complicated electromagnetic interference.
A typical electronic communication system, such as GPS receiver, unmanned aerial vehicle’s (UAV’s) data link, and radar, faces multi-dimensional and complicated electromagnetic interference in operating environment. To measure the antiinterference performance of the electronic communication system in the complicated electromagnetic interference environment, a method of multi-dimensional and complicated electromagnetic interference hardware-in-the-loop simulation in an anechoic room is proposed. It takes into account the characteristics of interference signals and the positional relationship among interference, the receiver and the transmitter of the electronic communication system .It uses the gray relational method and the angular domain mapping error correction method to control the relevant parameters, the microwave switch and so on, thereby achieving the approximately actual mapping of the outdoor multi-dimensional and complicated electromagnetic interference in the anechoic room. To ver ify the effectiveness of this method, the multi-dimensional and complicated electromagnetic interference of the UAV’s data link is simulated as an example. The results show that the degree of correlation between the calculated signal to interference ratio of the data link receiver in the actual scene and the measured signal to interference ratio of the data link receiver simulated with this method in the anechoic room is 0.968 1, proving that the method is effective for simulating the complicated electromagnetic interference.