【摘 要】
：
Real-time and high-resolution imaging is demonstrated based on field trial detection of a non-cooperative target using a photonics-based inverse synthetic aperture radar (ISAR). By photonic generation and de-chirping of broadband linear frequency modulati
【机 构】
：
KeyLaboratoryofRadarImagingandMicrowavePhotonics,MinistryofEducation,NanjingUniversityofAeronauticsa
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
Real-time and high-resolution imaging is demonstrated based on field trial detection of a non-cooperative target using a photonics-based inverse synthetic aperture radar (ISAR). By photonic generation and de-chirping of broadband linear frequency modulation signals, the radar can achieve a high range resolution thanks to the large instantaneous bandwidth (8 GHz at the K band), as well as real-time ISAR imaging using low-speed analog-to-digital conversion (25 MSa/s). A small-size unmanned aerial vehicle is employed as the non-cooperative target, and ISAR imaging is realized with a resolution far better than those achieved by the previously reported photonics-based ISARs. The capability for real-time ISAR imaging is also verified with an imaging frame rate of 25 fps. These results validate that the photonics-based radar is feasible in practical real-time and high-resolution ISAR imaging applications.
其他文献
利用50 MHz和1 MHz的重复频率光子晶体光纤飞秒激光分别在45#钢表面产生了微浮雕结构。实验发现微浮雕结构的高度和宽度与入射激光功率、激光扫描速度以及脉冲重复频率有关。通过调整这些参数, 可以实现对微浮雕形态结构的精确控制。对微浮雕结构的产生机制进行了初步分析, 发现微浮雕结构的产生与高重复频率飞秒激光的热积累效应有关。热积累导致了45#钢的表面熔化, 在液体表面张力和温度梯度力共同作用下, 产生了微浮雕结构。
Distributed feedback fiber lasers with multiple phase shifts are fabricated and investigated. Single longitudinal mode lasers with single polarization are obtained by the structure design with two phase shifts. No obvious differences in laser performance,
在光电跟踪中,对于低信噪比(SNR)的非对称激光目标图像,采用对Z.Zeev的方法改进过的宏像素质心迭代法来定位目标可明显提高抗噪声能力。该方法利用最大宏像素概念对目标区域进行初步估计,减少了计算量,提高了目标覆盖率。通过改进权值函数和比例函数,进一步提高了抗噪声能力。对于128 pixel×128 pixel的远场红外光斑图像,大小约为4 pixel×4 pixel的非对称目标,当信噪比为-5
本文利用计算机模拟方法,模拟CPM染料激光器中高阶孤子的形成过程,获得了λ=610nm的一、二、三阶稳定的孤子数值解,高阶孤子脉宽为70fs,孤子周期相当于一个光脉冲在腔内往返200次。
改变外色散腔半导体激光器的温度、电流和腔长,可实现复盖调谐范围内的连续调谐和准确调谐.本文叙述连续调谐和准确调谐的原理与实验结果.
Strong nonlinear, electro-optical, and thermo-optical properties of lithium niobate (LN) have gained much attention. However, the implementation of LiNbO3 in real devices is not a trivial task due to difficulties in manufacturing and handling thin-film LN
发散角为4.7×10-3弧度,残余多谱勒宽度7兆赫的原子束与线宽6兆赫的可调谐染料激光正交,激光频率在30千兆赫范围扫描,测得6Li和7Li的22P能级的精细结构分裂分别为9.7±0.4和10.5±0.5千兆赫,22P1/2能级的同位素位移为10.7±0.6千兆赫。激光频率作2.5千兆赫扫描,测得7Li的22P1/2←22S1/2跃迁的四条超精细结构谱线的间距依次为88±11、730±73和92±7兆赫,当光强为4毫瓦/厘米2时,记录的谱线宽度为22兆赫。对影响谱线宽度、相对强度及测量精度的一些因素也进行
在不同焊接参数下对QP1180高强钢薄板进行激光焊接试验,对接头的显微组织、显微硬度、拉伸性能及杯突成形性能进行了分析。研究结果表明:在热影响区的回火区(软化区)形成了回火马氏体组织,导致该区存在明显的软化;提高焊接速度和降低热输入可显著降低软化程度;软化区受到两侧强体的约束而得以强化,导致拉伸后最终断裂在母材处,强度与母材相当;提高焊接速度和增加焊缝偏移可显著提高杯突值,高焊接速度下的焊板垂直于焊缝开裂,具有高杯突值,低焊接速度下的焊板沿软化区平行于焊缝开裂,具有低的杯突值;随着焊缝偏移的增大,杯突值增
Photoacoustic imaging and microwave-thermoacoustic imaging are innovative hybrid imaging techniques that have experienced rapid development in recent years. Photoacoustic imaging is based on the photoacoustic effect. When the laser pulses (the width of th