论文部分内容阅读
在车床上加工梢孔或外圆锥度置。这些方法,都存在着劳动量大、我厂采用了如图1的自动装置,它有节并能得到合乎要求的稍孔或外圆锥了体力劳动,提高了工作效率,并保操作时,利用车床光杆1(图2)3,使小刀架作自动往复运动,即可时,常采用手动小刀架或仿形板等装效率低,或需增添装置等缺点。最近以下的优点:1,万能性好,可自动调度;2,结构简单,制造容易;3,减轻证了质量。的转动来带动槽轮2,通过绞链轴
Machined in the lathe hole or outer cone position. These methods, there is a large amount of labor, I plant using the automatic device shown in Figure 1, it has the section and can meet the requirements of a slight hole or outer cone of manual labor, improve work efficiency, and security operation, the use of Lathe polished rod 1 (Figure 2) 3, so that the knife holder for automatic reciprocating motion, you can often use manual small knife rack or copyboard installed inefficient, or the need to add devices and other shortcomings. Recently the following advantages: 1, good versatility, automatic scheduling; 2, the structure is simple, easy to manufacture; 3, to reduce the quality of the card. The rotation to drive sheave 2, through the hinge axis