论文部分内容阅读
我们知道,线切割控制台只能以十进制形式显示J计数长度,而对x、y的坐标值则以二进制形式分别显示在x、y寄存器中。如果我们能借用J显示部分来分别有序地显示x、y、J的数值,那末就能很直观方便地与编程指令对照检查纸带穿孔的正确与否了! 这里的关键是怎样使x、y的坐标值也能在J数码管中显示出来。只要把置J控制门接地址寄存器1端的二个头断开即可,这样
We know that the wire cut console can only display the J count length in decimal form, while the coordinate values for x, y are displayed in binary form in the x, y registers, respectively. If we can use the J display part to display the values of x, y, and J respectively in an orderly manner, then it is very intuitive and convenient to check the correctness of the tape hole with the programmed instructions! The key point here is how to make x, y coordinate value can also be displayed in the J-tube. Just set the J control gate address register 1 end of the two heads can be disconnected, so