论文部分内容阅读
在某氧气厂球缸区管道支架基础的设计中,因山区地面紧张,不得不把管道支架布置在稳定的土坡上。如图1所示。在这种条件下,基础(或垫层)的埋置深度如何确定?如果将支架基础(或垫层)底面标高设在挡墙顶面标高以下,那么,基础(或垫层)太深;能否把支架基础底面标高设在地面(斜坡)以下1.5m左右,又感到没有把握。最后我们是这样考虑和处理的,现介绍如下,以
In the design of the pipe support foundation of an oxygen factory in the spherical cylinder zone, the pipe supports had to be placed on a stable soil slope due to the tightness of the mountainous terrain. As shown in Figure 1. Under such conditions, how deep is the foundation (or cushion) buried? If the base of the foundation (or cushion) is set below the elevation of the top of the retaining wall, the foundation (or cushion) is too deep; Whether or not the base of the foundation of the foundation can be set at about 1.5m below the ground (slope) is not sure. Finally, we have considered and dealt with this way. Now we introduce it as follows.