Characteristics of Underground Water Flow at Different Water Levels in Tianshengan Karst Area, Yunna

来源 :地质学报(英文版) | 被引量 : 0次 | 上传用户:tanjich
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Three tracing tests from the same injection point executed at low, medium, and high water levels in the karst aquifer near Tianshengan village, Lunan Stone Forest, Yunnan Province, China, have revealed the basic properties of underground water flow. They showed the general directions of water flows; tracer concentrations were observed at six successive points allowing for the calculation of apparent dominant flow velocities at these sections towards the Dalongtan karst spring. For the high water level, the discharge between single sections was between two and 10 times greater than that at low water level. For the medium water level, the flow velocity at different sections was between 1.4 and 3.7 times faster than that at low water level; and for high water level, it was between 1.3 and 2.7 times faster than that at medium water level. The fastest water flow appeared at the first section (23 cm/s at medium water level); and the slowest (0.6 cm/s at low water level) appeared where water flow must cross the Tianshengan fault (north-south direction), and later, a layer of 20-30 m thickness of quartz sandstone and shale clay-stones. It was also possible to calculate the recovery of the tracer for point 4, Dakenyan, where discharge was measured. At the medium water level, 50% of the injected tracer was detected a half-day after its first appearance and at low water level after more than 3 days. The previously published research illustrates the transport velocities of possible contaminants and their solubilities in water at different hydrological conditions.
其他文献
Through the research into the characteristics of 7-DoF high dimensional nonlinear dynamics of a vehicle on bumpy road, the periodic movement and chaotic behavio
In the carpet tufting machine, feed milers are used to guide the yams positively. Mter deducing the general Euler formula of yarn tension under positive guide o
The hybrid slip model used to generate a finite fault model for near-field ground motion estimation and seismic hazard assessment was improved to express the un
A consistency condition is developed for computed tomography (CT) projection data acquired from a straight-line X-ray source trajectory.The condition states tha
本文通过对荣华二采区10
The iterative reconstruction algorithms for X-ray CT image reconstruction suffer from their high computational cost.Recently Nvidia releases common unified device architecture(CUDA),allowing developer
The binding function of EGF1 domain peptide with tissue factor(TF)and its ability of triggering coagulation were explored.The TF expression model in vitro was e
Considering the effects of particle crushing and intermediate principal stress on material yielding strength,the spatial mobilization plane (SMP) yielding crite
为探究吕家坨井田地质构造格局,根据钻孔勘探资料,采用分形理论和趋势面分析方法,研究了井田7
The differences of the microstructure and mechanical property between metal mould and sand mould cast Mg-10Gd-3Y-Zr alloy were investigated both under as-cast c