【摘 要】
：
Neodymium doped-yttrium aluminum garnet (Nd: YAG) transparent polycrystalline ceramics already become substitutes of single crystals because they are provided w
【机 构】
：
School of Materials and Chemical Engineering,The First Research Laboratory
论文部分内容阅读
Neodymium doped-yttrium aluminum garnet (Nd: YAG) transparent polycrystalline ceramics already become substitutes of single crystals because they are provided with easy fabrication, low cost, large size, highly doped concentration, high heat conductivity, mass fabrication, multi-layers and multi-functions. The Nd: YAG precursor powders with loosely dispersed, slightly agglomerated, super fine and YAG cubic crystal phase were synthesized at 1100 ℃ by the hocal stabilizer, TEOS as sintering additive. The Nd:YAG transparent ceramics were prepared after being vacuum sintered at 1700 ℃ for 5 h. The Nd:YAG ceramic materials were characterized by the TG-DTA, XRD, FT-IR, TEM, FEG-ESEM and FT-PL. The results show that the crystallization temperature of YAG is 850 ℃ and the intermediate crystal phase YAP forming during the heat treatment transforms to YAG cubic crystal phase at 1050 ℃. The lasing wavelength of (Nd0.01Y0.99)3Al5O12 transparent ceramics is 1.065 μm and there exists a slight red-shift compared to the single crystal with the same chemical composition. The optical transmittance is 45% in the visible light and 58% in the near infrared light and the optical transmittance descends with the decreasing the wavelength.
其他文献
Network-induced delay and jitter are key factors causing performance degradation and instability of NCSs (networked control systems). The relationships between
The CCT curves of supercooled austenite were investigated by using THERMECMASTOR-Z simulation machine, test samples refined from 50 kg vacuum induction furnace
Si3 N4/TiC nanocomposite ceramics have been fabricated by hot pressing technique with Al2O3 and Y2O3 as additives.The results showed that well dispersed composi
The structure and disorder-order transformation of NdxFe60.5-xPt39.5(x = 0, 0.5, 1.0, 1.5) alloys were investigated in situ by high temperature X-ray diffractio
In order to improve the quality of the bio-active coating on medical grade CoNiCrMo substrate, hydroxyapatite(HA) coatings were produced via low-temperature dip
TiO2/SiO2 aerogels with different molar ratio of SiO2/TiO2 were prepared via non-supercritical method using tetrabutyl titanate and silica sols as raw materials
Mobile robot global path planning in a static environment is an important problem. The paper proposes a method of global path planning based on neural network a
After the investigation on partial remelting of thixotropic magnesium serial alloys (ZK60) by near non-equilibrium liquidus casting (NNLC), the primary solid gr
Superplasticity of as-rolled ZK60 magnesium alloy sheets, with the average grain size of 8.2μm, was investigated at a strain rate of 5.56×10-4-5.56×10-2 s-1
By a simple phase field model, a series of numerical simulations of solidification microstructure was performed to show a rich variety of dendritic patterns. At