论文部分内容阅读
针对当前无线监测网络节点存在无线通信距离小、数据传输周期短等问题,设计并实现了一种基于0.18μm CMOS工艺的智能传感器网络节点。该无线传感器网络节点由无线传感器模块、CC2430处理器模块、无线通信模块以及电源模块构成。其中,CC2430处理器模块采用0.18μm CMOS工艺控制电流损耗和模式变换时间,提高电源的运行周期,并采用0.18μm CMOS工艺中低噪声放大器和UQ下变频对天线采集的射频信号进行操作,获取2.4GHz的数据扩频,增强CC2420的无线通信抗干扰性能。设计了无线传感器网络节点中的SHTIO温湿度传感器、MS5534B集成压阻式压力传感器和ADXL202E双轴加速度传感器,并给出节点软件的结构和主程序流程。实验检测结果表明,设计的无线传感器网络具备较优的运行性能,丢包率较低,通信距离与运行周期明显优于传统方法。
Aiming at the problems such as short distance of wireless communication and short transmission period of data in current wireless monitoring network nodes, an intelligent sensor network node based on 0.18μm CMOS process is designed and implemented. The wireless sensor network node consists of wireless sensor module, CC2430 processor module, wireless communication module and power module. Among them, the CC2430 processor module uses 0.18μm CMOS process to control the current consumption and mode conversion time to improve the power supply operation cycle, and 0.18μm CMOS low noise amplifier and UQ down-conversion of the RF signal collected by the antenna operation to obtain 2.4 GHz spread spectrum data to enhance the anti-jamming performance of CC2420 wireless communications. The SHTIO temperature and humidity sensor, MS5534B integrated piezoresistive pressure sensor and ADXL202E biaxial acceleration sensor in the wireless sensor network node are designed. The structure and main program flow of the node software are given. Experimental results show that the designed wireless sensor network has better running performance, lower packet loss rate, and better communication distance and operation cycle than the traditional method.