论文部分内容阅读
我厂一台X63W万能铣床横向丝杠副托架撞裂。在更换新托架时,其托架孔的加工我们采用了如下方法: (1)先将床鞍底部各导轨面与升降台上部各导轨面配磨(或配刮)好。再将镶条、压板配刮好。然后把床鞍、升降台合装在一起,并将床鞍锁紧在升降台上。 (2)将所要更换的新托架底面刮好,装在床鞍下平面上,拧紧螺钉,合铰销孔并装好定位销。
I plant a X63W universal milling horizontal screw vice bracket cracked. In the replacement of the new bracket, the bracket hole processing we use the following methods: (1) the first saddle at the bottom of the rail surface with the lifting table above the rail surface with grinding (or with scraping) good. Then insert the strip, with a good scraping plate. Then the saddle, lifting platform together, and the saddle locked in the lifting platform. (2) The bottom surface of the new bracket to be replaced scraped, mounted on the lower plane of the saddle, tighten the screws, hinge pin and install the positioning pin.