论文部分内容阅读
我们在安装感应同步器定滑尺时,发现定尺与滑尺的间隙要求0.25± 0.05mm调整起来很费事,就采用了下面的方法。如图所示,用两片0.25mm塞尺按需要的长度剪断,再用两块金属或胶木板把
When we installed the induction synchro set slider, we found that the length of the slider and slide the gap requirements of 0.25 ± 0.05mm to adjust it is cumbersome to use the following method. As shown, cut two 0.25mm feelers in the required length and then use two pieces of metal or bakelite