论文部分内容阅读
单传动轴三辊Y型轧机于1954年由德国KOCKS公司推出,至今已近五十年,近二三十年已在国内有色金属棒线管材加工中广泛使用,取得成效。但是长期以来这种轧机由于受机架内两对锥齿轮啮合的限制,只能在停机时对三个轧辊进行径向微调(压下或提升);因此大大降低轧辊及整个轧机的使用效率……。 本文作者近年来致力于三辊、四辊与多辊轧机的研究,认为用锥齿轮付做为三辊与多辊轧机轧辊同步旋转的传动部件,确实让轧机的结构简单轻
Single-shaft three-roll Y-type rolling mill in 1954 by the German KOCKS company launched nearly 50 years, almost two decades has been in the domestic non-ferrous metal pipe processing widely used and achieved results. However, for a long time, due to the restriction of the meshing of the two pairs of bevel gears in the machine frame, the rolling mill can only finely adjust (press or lift) the three rollers in a radial direction at the time of shutdown, thereby greatly reducing the using efficiency of the rollers and the entire rolling mill ... .... In recent years, the author of this paper devoted himself to the research of three-roll, four-roll and multi-roll mills, and believed that the use of bevel gears as the transmission components for the synchronous rotation of the three rolls and the multi-roll mills did make the structure of the rolling mill simple