论文部分内容阅读
Stable operating region in the HL-1M tokamak has been extended by means of wall conditioning, core fuelling and current control techniques. The mechanisms of the extension are analyzed in this paper. Lithiumization diminishes the impurities and hydrogen recycling to the lowest level. After lithiumization a high density up to 7×1019 m-3 was obtained easily by strong gas puffing with ordinary ohmic discharge alone. More attractively we found that metal Li-coating exhibited the effects of wall stabilization. The low qα limit with higher density was extended by a factor of 1.5-2 in comparison with that for boronization, and 1.2 for siliconization. Siliconization not only extended stable operating region significantly by itself, but also provided a good target plasma for other experiments of raising density limit. Core fuelling schemes are favourable especially for siliconized wall with a higher level of medium-Z impurity (Z = 14). After siliconization the maximum density near to 1020 m-3 was achieved by a combination of supersonic molecule beam injection and multipellet injection. The new defined slope of Hugill limit illustrating more clearly the situation under low qα and high ne discharges was created to indicate the new region extended by combining IP ramp-up with core fuelling. The slope with a large Murakami coefficient increased by a factor of 50-60 %.
Stable operating region in the HL-1M tokamak has been extended by means of wall conditioning, core fuelling and current control techniques. The mechanisms of the extension are analyzed in this paper. Lithnesiumization diminishes the impurity and hydrogen recycling to the lowest level. After Lithization a high density up to 7 × 1019 m-3 was obtained by strong gas puffing with ordinary ohmic discharge alone. More low we found that metal Li-coating exhibited the effects of wall stabilization. The low qα limit with higher density was extended by a factor of 1.5-2 in comparison with for for boronization, and 1.2 for siliconization. Siliconization not only extended stable operating region significantly by itself, but also provided a good target plasma for other experiments of raising density limit. Core fuelling schemes are favourable especially for siliconized wall with a higher level of medium-Z impurity (Z = 14). After siliconization the maximum density near to 1020 m-3 was achieved by a combination of supersonic molecule beam injection and multipellet injection. The new defined slope of boltill shows clearly that the situation under low qα and high ne discharges was created to indicate the new region extended by combining IP ramp-up with core fuelling The slope with a large Murakami coefficient increased by a factor of 50-60%.