基于稀土功能材料的新型多功能肿瘤诊疗剂的研究

来源 :2014中国功能材料科技与产业高层论坛 | 被引量 : 0次 | 上传用户:guoyurun
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
近年来,基于稀土功能材料的上转换发光纳米颗粒(UCNPs)作为一种新型的多功能纳米诊疗剂,具有近红外光激发、上转换发光(UCL)成像、磁共振成像(MRI)等功能优势,在肿瘤的多模式影像诊断和高效治疗中的应用基础研究倍受关注.
其他文献
纳米尺度的催化过程已经被深入广泛研究.然后究其具体的细节而言距离实际应用还有很远的距离.特别是针对催化材料的稳定性.催化材料的可持续发展注重四个部分:(1)原料的获取需要容易和低廉;(2)制备过程简单和低廉,且可以批量合成和对环境无害;(3)催化剂材料高效率;和(4)催化材料在苛刻的反应条件下能够稳定.
会议
利用超临界流体逆向蒸发过程制备了阿昔洛韦脂质体,并详细考察了工艺条件对脂质体粒径和包覆率的影响.研究结果表明:该过程可成功制备出平均粒径330nm、包覆率27.69%的阿昔洛韦药物脂质体.
Activated fly ash (AFA), AFA/TiO2 and AFA/TiO2/cement based photocatalytic materials were firstly produced for improving the utilization ratio and photocatalytic effect of TiO2 in cement concrete mate
本工作提出一种简便、高效构筑高度有序石墨烯二维阵列的新方法。利用微接触印刷和自组装技术,在金基底表面形成亲水/疏水交替的自组装单分子膜图案。在亲水区域凝结得到水珠阵列,以此作为模板,辅助构造石墨烯的有序结构。
采用叠层干压成型工艺,分别以HH2((Zn0.7,Mg0.3)TiO3和(Ni0.8Zn0.12Cu0.12)Fe1.96O4按质量比为1:1混合粉体)和ZMT1((Zn0.9, Mg0.1)TiO3)作为中间层材料,与ZMT3 ((Zn0.7, Mg0.3)TiO3)和NZC ((Ni0.8Zn0.12Cu0.12)Fe1.96O4)在900℃共烧,制备叠层共烧体.
Quantum dot sensitized solar cells (QIDSCs) have attracted great interest in recent years due to their higher theoretical photoelectric conversion efficiency.
Ni-P-multi-walled carbon nanotubes (Ni-P-MWNTs) composite coating was successfully codeposited on 45 steel substrate by electroless plating.
Preparation of nitrogen-rich mesoporous carbon materials is an effective way to achieve super capacitor with high specific energy and high power performance.Polyacrylonitrile base mesoporous carbon ma
A simple and mild wet-chemical approach was developed for the synthesis of nanostructured In (OH)3 thin film.By employing a novel hydroxyl (OH-) solution corrosion-base approach,In (OH)3 nanocube film
Silicon nanoparticles have extraordinary electrochemical performance for lithium-ion batteries.This paper gives an improved low temperature solution synthesis route of Si NPs.
会议