Study of the fusion point between PM-PCF and Panda Fiber and its influence to Interferometric Fiber-

来源 :2016年第二届光子学与光学工程国际会议暨第八届西部光子学会议 | 被引量 : 0次 | 上传用户:luzhenning
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  Thermal stability of a Fiber-Optic Gyroscope using Polarization-Maintaining Photonic Crystal(PM-PCF)was studied.And the thermal sensitivity of the PM-PCF and fiber coil was measured.By using an OCDP method,the polarization cross talking causing phase error of the FOG was analyzed.The contrast experiment result of the FOGs with PM-PCF coil and PMF coil showed that using PM-PCF instead of PMF can improve the FOGs bias thermal stability by about 50%.
其他文献
  Recently,hyperspectral image projectors(HIP)have been developed in the field of remote sensing.For the advanced performance of system-level validation,targe
会议
  For a general full-Stokes polarimeter(FSP),there are two types of noises,signal-dependent Poisson shot noise and signal-independent Gaussian additive noise,
  Plume is the main infrared source of a long-endurance UAV,and its infrared radiation numerical calculation is very important for calculating the infrared ch
  Spectrally resolved interferometry(SRI)technology is a high precision laser interferometry technology,whose short non-ambiguity range(NAR)increases the prec
  Sparse decomposition is one of the core issue of compressive sensing ghost image.At this stage,traditional methods still have the problems of poor sparsity
  In this work,we propose a new scheme of generating high quality frequency quadrupling signal for millimeter-wave wireless communication system.The frequency
  In this paper,a colorful schlieren system without any protecting windows was introduced which results in that the 1.2m primary mirror would directly be conf
  In this work,we propose a schematic design for the biochemical sensor,which is based on the polyatomic photonic crystal ring resonator(PCRR).Unlike with the
  In this paper,a novel fiber Bragg grating(FBG)sensor which can measure the temperature and strain simultaneously is presented.The cladding layer of the prop