• 不 限
  • 期刊论文
  • 硕博论文
  • 会议论文
  • 报 纸
  • 英文论文
  2. 您的位置
  3. 首页
  4. 会议论文
  5. Research on the composites of Macro porous polymer-matrix and HNIW

Research on the composites of Macro porous polymer-matrix and HNIW

来源 :2014中国功能材料科技与产业高层论坛 | 被引量 : 0次 | 上传用户：jiaonimaqubao110
【摘 要】
：
In order to solve the problem of the microscale charge withMEMS pyrotechnic devices,a new idea was proposed in this paper.Porous polymer fiber prepared with electrospin method was regarded as matrix w
【作 者】
：
Li Yaru Ren Hui Li Zhenhua Jiao Qingjie 
【机 构】
：
State Key Laboratory of Explosion Science and Technology,Beijing Institute of Technology,Beijing 100
【出 处】
：
2014中国功能材料科技与产业高层论坛
【发表日期】
：
2014年2期
【关键词】
：
macro porous fiber HNIW liquid phase impregnationmethod ignition 
下载到本地 , 更方便阅读
下载此文 赞助VIP
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
　　In order to solve the problem of the microscale charge withMEMS pyrotechnic devices,a new idea was proposed in this paper.Porous polymer fiber prepared with electrospin method was regarded as matrix which was filled with HNIW by liquid phase impregnation method,structure and propertiesof products wereanalyzed
其他文献
Analysis of solvent properties of mandarin oil
Mandarin oil were extracted twice to ensure the purity of limonene, respectively.The spectrum testandSolvent solubility of chemical analysis indicate that it is a certain fluorescence effect and the u
会议
recyclingoptical spectroscopypolymeric biomaterialsoptical absorptionorange
Phase Transition of Ball-Milled Ni50-xMn37ln13Cox (x=0,5) Alloy Powders
Ni50-xMn37In13Cox (x=0,5) alloy powders were obtained by ball-milling from the corresponding ribbonprecursors.The as-milled NixMn37In13 and Ni45Mn37In13Co5 powders show disordered fct and fcc structur
会议
Martensitic transformationPhase transitionBall-millingPowder
相转移催化剂对聚吡咯界面聚合性能的影响研究
采用化学氧化界面聚合法，以FeCl3为氧化剂，以吡咯为单体，在相转移催化剂辅助下合成聚吡咯薄膜。利用扫描电子显微镜、热失重分析及电化学测试(循环伏安测试、交流阻抗测试)对其结构与性能的变化进行了研究。
会议
界面聚合聚吡咯相转移催化剂比电容
Synthesis and properties of carbon and yttrium co-doped TiO2 photocatalyst
TiO2 photocatalysts doped with different element of C and Y were synthesized by sol-gel process using glucose, yttrium nitrate and tetrabutyl titanate as precursors.Samples characterized by XRD, XPS,
会议
TiO2C-Y-dopingSol-gel chemistryphotocatalyst
温度对铝夹层AZ31B/Cu瞬间液相扩散连接接头的显微组织与力学性能的影响
为实现镁合金AZ31B与工业纯铜的可靠连接,以Al为中间层对两者进行过渡液相扩散焊的瞬间液相扩散焊.研究结果表明,在460℃、60 min、2.5 MPa条件下,AZ31B/Al/Cu接头形成了宽度约为160μm的扩散区.
会议
AZ31BCu铝夹层瞬间液相扩散连接显微组织力学性能温度
In-doped-CdS Quantum Dot Sensitized Solar Cells
Quantum dots sensitized solar cells (QD-SCs) have high theoretical conversion efficiency, and they have potential application in energy field.But the conversion efficiency of QDSCs have not made a big
会议
In-doped-CdSQDSCsSILAR cyclesdoping ratios
Development of W/Cu plasma facing component for fusion device
Tungsten was considered a promising plasma facing material in fusion device due to its high sputtering threshold, the high melting point,and so on.
会议
tungstenplasma facing component
Nanoscale Hollow-bubbly Polypyrrole Obtained via Interfacial Polymerization with Phase Transfer Cata
Crown ether 18C6 was used as a phase transfer catalyst (PTC) for the interracial polymerization of polypyrrole (PPy).Usually, in interfacial reacting system, oxidant FeCl3 was dissolved in deionized w
会议
PolypyrroleInterracial polymerizationPhase transfer catalystCrown ether 18C6
铝合金化学镀预处理工艺研究进展
铝合金表面要获得结合力良好的化学镀镍层，关键在于前处理。本文介绍了常见的铝合金化学镀镍预处理工艺，阐述了各种预处理方法的原理。最后指出了铝合金化学镀预处理的发展方向。
会议
铝合金化学镀镍前处理
化学镀Ni-B/Ni-B-B4C复合镀层的耐蚀及耐磨性能
采用低温化学液相沉积技术，以45＃钢为基体材料，制备了Ni-B合金镀层及Ni-B-B4C复合镀层；利用光学显微镜和X射线衍射仪对镀层的截面、表面形貌以及相组成进行了观察和表征，采用电化学工作站及摩擦磨损试验机对复合镀层的耐腐蚀和耐磨性能进行了测试。
会议
化学镀Ni-B合金B4C颗粒耐蚀性耐磨性