Variation of Surface Structure and Tribological Properties of Carbon Fabric Composites used as Wet C

来源 :第二届中国国际复合材料科技大会 (CCCM-2) | 被引量 : 0次 | 上传用户：t7899

【摘要】

：

　　Carbon fabric reinforced phenolic composites were prepared by dip-coating and hot-press techniques, and then their surface structure and wet tribological pr

【作者】

：

Fei Jie Li Wenbin Huang Jianfeng Cao Liyun Yao Chunyan

【机构】

：

School of Materials Science & Engineering,Shaanxi University of Science and Technology,Xi'an Shaanx

【出处】

：

第二届中国国际复合材料科技大会 (CCCM-2)

【发表日期】

：

2015年期

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　Carbon fabric reinforced phenolic composites were prepared by dip-coating and hot-press techniques, and then their surface structure and wet tribological properties were investigated in the whole service life of wet clutch.

其他文献

The Electrical Properties of Glass Fabric Reinforced Composites and the Relationship between the Mec

　　The dielectric properties of glass fabric reinforced composites with different structure configurations were investigated in this paper.Herein, the differen

会议

Mechanical properties and dynamic mechanical properties of SCF-and SFCM-in-situ-reinforced phenolic

　　Sisal cellulose fiber (SCF) and sisal fiber cellulose microcrystal, produced with sulfate pulping method and ball-milling approach separately, were in-situ

会议

New Way of Strengthening and Toughening for Carbon Fiber Reinforced Polyphenylene Sulfide (CF/PPS) C

　　In this study, the effect of pressure-induced flow (PIF) processing on mechanical properties of short carbon fiber (CF) reinforced polyphenylene sulfide (PP

会议

Tribological properties and Wear mechanisms of carbon fabric reinforcedphenolic composites under the

　　Carbon fabric reinforced phenolic composites were prepared by dip-coating and hot-press techniques, and then their wet tribological properties were investig

会议

Cure Kinetics and time-temperature-transformation (TTT) Diagram of Phenolic Resin and Polyurethane B

　　In order to optimize the low-cost RFI (resin film infusion) process parameters, the cure kinetic model and the time-temperature-transformation (TTT) cure di

会议

Thermal insulation properties and mechanical behavior of aerogel/polytriazolesandwich composites

　　A sandwich structure was designed and fabricated based on carbon fiber reinforced polytriazole skins bonded to an aerogel core for an effective combination

会议

Study of High Temperature Resistant Carbon Fiber Sizing Agent in Domestic

　　Carbon fiber sizing agent can protect the carbon fiber, at the same time is the interface, setted as the third phase in carbon fibers reinforced resin matri

会议

Experimental Investigation on the Impact Performance of Concrete filled Steel Tubes with FRP Composi

　　Experiments were conducted to study the dynamic response of simply supported beams of concrete filled steel tubes wrapped with fiber reinforced polymer (FRP

会议

Experimental Study of Steel ReinforcedRecycled Concrete Columns after HighTemperature Reinforced By

　　The use of externally bonded carbon fiber reinforced polymer (CFRP) to strengthen deficient reinforced concrete columns has gained in popularity and has bec

会议

Cryogenic Mechanical Properties of Graphene/Carbon Fibers/Brominated Epoxy/Cyanate Ester Composites

　　The influence of oxide graphene (GO) on the tensile strength and bending strength at room temperature (RT) and cryogenic temperature (77 K) of carbon fiber/

会议

Variation of Surface Structure and Tribological Properties of Carbon Fabric Composites used as Wet C

其他学术论文