【摘 要】
：
To investigate the effect of nozzle geometry on diesel spray characteristics,spray experiments were carried out in a spray chamber.Three different single-hole nozzles were used:(1)nozzle N1-outlet dia
【机 构】
：
Department of Applied Mechanics,Chalmers University of Technology,Gothenburg,Sweden
【出 处】
：
13th International Conference on Liquid Atomization and Spra
论文部分内容阅读
To investigate the effect of nozzle geometry on diesel spray characteristics,spray experiments were carried out in a spray chamber.Three different single-hole nozzles were used:(1)nozzle N1-outlet diameter 140 μm with kfactor 0;(2)nozzle N2-outlet diameter 140 μm with k-factor 2;(3)nozzle N3-outlet diameter 136 μm with kfactor 2.Two constant gas densities of 15 kg/m3 and 30 kg/m3 were maintained under non-evaporating(ambient temperature 40 ℃)and evaporating(ambient temperature 400 ℃)conditions.The range of injection pressure was from 800 bar to 1600 bar.Liquid phase spray penetration and local spray cone angle along the spray profile were measured based on high speed shadowgraph images.In addition,spray momentum flux was measured.It was found that the effect of nozzle geometry on the liquid phase penetration and local spray cone angle were different for different gas density and injection pressure.Under non-evaporating conditions,as injection pressure was increased,nozzle N1 without conicity showed slightly slower liquid penetration and larger local cone angle than nozzles N2 and N3 at the density 15 kg/m3.As the gas density was increased to 30 kg/m3,the difference between the three nozzles was more evident.Under evaporating conditions,nozzle N3 with conicity showed shorter liquid phase penetration than nozzle N1.As the gas density is increased to 30 kg/m3,comparing the two nozzles(N1 and N2)which have the same outlet diameter but with different conicity,nozzle N2 with conicity showed longer liquid phase penetration than nozzle N1 without conicity.
其他文献
The performance of spark-ignition direct-injection gasoline engines can be influenced by the interactions between fuel spray and in-cylinder air charge characteristics.A highly atomized spray promotes
This work is focused on liquid metal droplet oscillation due to hydrodynamic disturbances generated by a water flow.The understanding and modeling of liquid metal drop deformation can help in comprehe
The objective of this study is the theoretical description of the melting of non-spherical ice particles applying a spheroidal shape approximation.Due to surface tension,melted water is assumed to acc
The spray atomization process is composed by several breakup mechanisms and intensively investigated to develop a robust numerical model to accurately predict the droplet behaviours.The spray breakup
Thermal Barrier Coating(TBC)is necessary to increase turbine inlet temperature of a high efficient gas turbine for a power station.The atmospheric plasma spraying is employed to process a well-establi
Fabrication of solution-processed thin film solar cells,such as polymer and perovskite solar cells,is a new and exciting application of Spray Technology.To address the efficient and low-cost fabricati
This paper summarizes the characterization of a pulsating conical jet-fuel spray within a swirling co-flow air,similar to typical gas turbine swirl combustor.The pulsation spray is generated by a piez
Large eddy simulation methodology coupled with volume of fluid(VOF)method was used to study the spray atomization process of N2H4/MMH liquid-liquid swirl coaxial injectors.The spray characteristics su
Biodiesel is now well known as the alternative fuel for air pollution reduction from internal combustion engines using diesel fuel.Because of its oxygen components,particulates into the exhaust gas de
The present research reports an experimental spray characterization of a generic double-swirl prefilming model aeroengine atomizer,which injects an annular liquid sheet of 0.5 mm thickness at the nozz