【摘 要】
：
Little work has been done on the accumulation characteristics of Ca2+ in the aerobic granules that cultivated in the continuous flow bioreactor.The contribution of Ca2+ on the biogranulation was studi
【出 处】
：
2012 Postdoctoral Symposium of China on Materials Science &
论文部分内容阅读
Little work has been done on the accumulation characteristics of Ca2+ in the aerobic granules that cultivated in the continuous flow bioreactor.The contribution of Ca2+ on the biogranulation was studied in a continuous flow airlift fluidized (CAFB), by comparing with the biogranulation without Ca2+ directly in this work.Precipitation of calcium in the aerobic granules, cultivated in this complete mixing bioreactor, was figured out by direct spectral and optical analysis.It was found calcium located throughout the center slice of the Ca-rich granules, rather than accumulated in the center area of the granules that cultivated in the sequencing batch reactor.Such difference was considered to be related the operational conditions of these two kinds reactors, whereas selective pressure was not controlled in the CAFB.Furthermore, CaCO3 was detected as the calcium crystalline mineral form which corresponded with other researchers work.It should be notice calcium augmentation in the granule promoted the accumulation of magnesium in the granules.Such phenomenon was first reported to our best knowledge.The magnesium was possibly presented at the form of Ca7Mg2P6O24 according to X-ray Diffraction analysis, or combined with the organic polymer together.
其他文献
Near infrared (NIR) light induced photothermal effect for Fe3O4 nanoparticles, contained in Pluronic F127 micelles, has been exhibited high photothermal converting efficiency.Heat was found to be rapi
Al2O3/Au nano-laminated composite coatings were prepared by means of magnetron sputtering.The coating was compact and with nano-laminated Al2O3 and Au layers.High temperature cyclic oxidation test was
Nanosphere-like Li2FeSiO4/C is synthesized via a solution method using sucrose as carbon sources under a mild condition of time-saving and energy-saving, followed by sintering at high temperature for
Semiconductor oxides with hierarchically hollow or porous architectures are considered to be the ideal structure for the gas-sensing applications due to their efficiently high surface area and surface
Carbon aerogels are nanostructure porous carbon materials which are derived via a sol-gel process with resorcinol and formodehyde and subsequent pyrolysis of the precursor aerogels.Due to their high s
Red-emission (Y0.95Eu0.05)2O3 submicron spheres and microplates have been selectively processed via hydrothermal precursor synthesis (150 ℃, 12 h) followed by calcination at 1000 ℃.Detailed characteri
A facial ultrasonic method was used to synthesize CoO/Graphene nanohybirds by employing Co4(Co)12 as cobalt precusor.The nanohybrids were characterized by SEM, TEM and XPS, showing that CoO nanopartic
A series of magnetic nanocomposites based on poly(ε-caprolactone) (PCL) and Fe3O4 nanoparticles were prepared using a facile in situ polymerization method.The chemical structures of the PCL/Fe3O4 nano
Ti matrix syntactic foams have potential for orthopaedic applications, because of their good biocompatibility, corrosion resistance and ability of varying the elastic modulus.Previous study conducted
The influence of different additives (poly-γ-glutamic acid, polyethylene glycol) on the thermostabitity of zearalenone-degraded enzyme at 70℃ has been studied in aqueous medium.The results obtained sh