• 不 限
  • 期刊论文
  • 硕博论文
  • 会议论文
  • 报 纸
  • 英文论文
  2. 您的位置
  3. 首页
  4. 会议论文
  5. Effects of different surface-modified SiCP on the microstructures and tensile properties of SiCP/201

Effects of different surface-modified SiCP on the microstructures and tensile properties of SiCP/201

来源 :第二届中国国际复合材料科技大会 (CCCM-2) | 被引量 : 0次 | 上传用户：loganhuang
【摘 要】
：
The pre-oxidized SiO2 layer and salt-bath plating Ti5Si3 coating layer were developed on the surface of SiCP.Effects of surface states on the microstructures and tensile properties of 2vol.% SiCP/2014
【作 者】
：
De-Long Yang Feng Qiu Wei-Xing Zhao Qi-Chuan Jiang 
【机 构】
：
Key Laboratory of Automobile Materials,Ministry of Education and Department of Materials Science and
【出 处】
：
第二届中国国际复合材料科技大会 (CCCM-2)
【发表日期】
：
2015年7期
【关键词】
：
SiCP/2014Al composites Surface modification Microstructure Tensile properties 
下载到本地 , 更方便阅读
下载此文 赞助VIP
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
　　The pre-oxidized SiO2 layer and salt-bath plating Ti5Si3 coating layer were developed on the surface of SiCP.Effects of surface states on the microstructures and tensile properties of 2vol.% SiCP/2014Al composites fabricated by stir casting were investigated.
其他文献
A high-temperature nanocomposite thermal interface material based on actively brazed carbon nanotube
In spite of the ultra-high thermal conductivity of an individual carbon nanotube (CNT), use of vertically oriented CNT arrays as thermal interface material (TIM) has largely been hindered by the high
会议
Preparation and Properties of A Novel Highly Thermal Stability N-propargyl Monomer Containing Benzox
N, N, N, N-tetra propargyl-5-amino-2-(p-aminophenyl) benzoxazole (TPAPB), a novel highly thermal stability propargyl functional compound containing benzoxazole ring, was proposed and synthesized using
会议
PropargylBenzoxazoleThermal stabilityPhase-transfer catalyticPurification
Effect of Pre-buckled Stress State on Buckling of Laminated Plates Subjected to Uni-axail Compressio
In this study an attempt has been made to incorporate the effect of actual pre-buckled stress distribution on the stability of laminated plates under uniform compressive load.For this a finite element
会议
bucklinglaminated platespre-buckled stressgeneralized plate model
The Effect of Impactor on Basalt Filament Wound CompositeTubes: Experimental Study
The aim of this study was to determine the effect of impactor sizes on basalt filament wound composite tubes under low velocity impact loads.Tubes with four different winding angle [±450]3, [±550]3, [
会议
Basalt TubesLow Velocity ImpactImpactorDamage
Numerical studies on tensile strength of fiber reinforced composites with rigid impurities and void
Carbon fiber reinforced composite has many advantages and has been applied in wide fields.This paper demonstrates the prediction of longitudinal tensile strength of carbon fiber reinforced composite b
会议
Carbon fibersTensile strengthInduced stress fieldVoid contentsRigid impuriti
New approach to produce highly dispersed graphene oxide-carbon nanotube hybrid reinforcement into al
In the last decade, carbon nanotubes (CNT) and Graphene nanoplatele (GNP) has been attracted a lot of attention in various polymer and ceramic composite systems to improve the mechanical and functiona
会议
Regenerated celluloseRubberHalloysitesIonic liquidNanocomposites
Effects of processing and graphene oxide content on mechanical and thermal properties of polyethersu
Polyethersulphone (PES) is an important special engineering plastic and has many engineering applications.In order to use PES in some areas where high mechanical and thermal properties are required, i
会议
Polyethersulphone (PES)short carbon fibers (SCFs)graphene oxide (GO)mechanica
The Interface Characterization of Graphene Oxide-Cellulose Nanocrystals Composite Fiber by Soft X-ra
Small angle X-ray scattering (SAXS) is an effective method to characterize the interface of quasi-dual-phase system.The interface parameter can be obtained by modified Porod formula at large q region.
会议
interface characterizationgraphene oxidecellulose nanocrystalsSAXS
Electrospun nanofibrous composites of polystyrene and cellulose nanocrystals: manufacture and charac
An electrospinning process was successfully utilized to manufacture polystyrene/cellulose nanocrystal (PS/CNC) nanofibrous mats.Morphology, crystallinity, thermal behavior, as well as mechanical and h
会议
Carbon nanotube reinforced Cu matrix composites by hot pressing for CNTs-embedded composite particle
Carbon nanotube (CNT)-reinforced copper composite was fabricated by hot pressing for CNTs-embedded copper composite particles, which involves solution phase synthesis of CNTs-implanted cuprous oxide c
会议