Preparation and Characterization of hydrophobic Carbon-Supported Pt3M (M=Fe, Co, Ni and Cr) Bimetals

来源 :the 4th International Conference on Structured Catalysts and | 被引量 : 0次 | 上传用户:libowen1
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  Tritium is produced through a neutron capture by the deuterium atom in heavy water which is used as a moderator and coolant in CANDU (Canadian Deuterium Uranium) reactors.Careful calculation pointed out that the generation tritium would be around 2×l03Ci/MW annually in this type reactor.In addition, gases and liquids containing a large amount of tritium need be handled in the International Thermonuclear Experimental Reactor (ITER).Therefore, it is necessary to remove tritium from heavy water, exhaust gases and liquids to reduce radiation level to the environment, upgrade the heavy water, and recover tritium to reuse it as reactor fuel.
其他文献
Introduction The study deals with the design of efficient exhaust gas cleaning system for biogas engines with particular reference to the development of active and durable catalyst for DeNOx.Biogas fu
With the strengthening of peoples environmental awareness as well as the stringent of countries environmental legislation, governance requirements for motor vehicle exhaust are increasingly high.Not o
For the next generation aircrafts, fuel-cooled thermal management, including endothermic cracking and reforming of hydrocarbon fuels, is an enabling technology for advanced aero engines and offers pot
Monolithic catalysts have attracted much attention due to their higher thermal stabilization, the better mechanical strength, the bigger specific surface area, the lower pressure drop, and the lower t
Titanium-containing mesoporous silicas have attracted much attention in the past decades have shown excellent activities in various oxidation reactions under mild conditions.However, those the catalys
Biodiesel, mainly comprising of fatty acids methyl esters that are derived from vegetable oils and animal fats, has emerged as an alternative fuel with wide acceptance.The oxygen content in the molecu
1.Introduction The dominant catalyst support for the auto exhaust catalyst is a monolith structure.This type of supports, which consist of single blocks of small parallel channels, are also called hon
Recently, a lot of effort to enhance engine performance over the entire spectrum of flight regimes by using catalytic cracking of hydrocarbon fuels to remove waste heat from aircraft systems has been
AFM coupled with Raman microscope is a new emerging technique that offers simultaneous analysis of both morphology and texture of material with the chemical information obtained with high spatial reso
Monoliths with hierarchical porosity have aroused great interest due to their potential applications in the industrial fields.These materials have been proven to be promising catalysts because the inc