论文部分内容阅读
The CCT(continuous cooling transformation)curve of the test steel was obtained on Gleeble-1500 thermal mechanical simulator based on the thermal dilation measurement.The test steels were the deformation with 40%under the temperature of 900℃ and then were cooled to room temperature at different cooling rates.The phase transformation law and hardness change rule were emphatically investigated at the cooling rate from 0.05℃/s to 30℃/s by optical microscopy(OM),scanning electron microscope(SEM)and Vickers hardness tester.The regression model of phase transformation was calculated.The results show that the transformation of ferrite and pearlite are inhibited,which cause the dynamic CCT curve shift to the right.The microstructure of the test steel consists of ferrite and pearlite after phase transformation at the cooling rate of 0.05℃/s; the granular bainite appears at the cooling rate of 0.5℃/s due to the interaction of Mo and B; as the cooling rate increases to 2℃/s,the microstructure mainly consists of lath bainite; the martensite is observed at the cooling rate of 2℃/s and there would be total martensite if the cooling rate is higher than 5℃/s and the grain growth rate is faster at the same time.The hardness of test steels increases with the increase of cooling rate,and increases obviously when the cooling rate is lower than 5℃/s.A theoretical basis is provided to obtain the best bainite/martensite composite microstructure.The martensitic transformation start temperature is 354.6℃ and the critical cooling rate is 5℃/s.The test value and the regression model can fit well and reflect the test value trend,showing a high precision of regression.